Subject	Re: Head gasket to use with torque/honing plate
Posted by	Tech@EPR on November 27, 2015 at 2:15 PM
	This message has been viewed 283 times.
In Reply To	Head gasket to use with torque/honing plate posted by ZXoltan on November 27, 2015 at 11:53 AM
Message	Myth...just use a cheap worn out cometic gasket. You definitely need to use a gasket though.
Follow Ups	Head gasket to use with torque/honing plate - ZXoltan 11:53:22 11/27/15 Re: Head gasket to use with torque/honing plate - Tech@EPR 14:15:00 11/27/15 so an old previously used cometic will do? thickness matter? (n/m) - Zbullet 17:22:44 11/27/15 Re: so an old previously used cometic will do? thickness matter? - Tech@EPR 17:41:35 11/27/15
Post a Followup	You cannot reply to this message because you are not logged in.