Subject	Yes, though that's only if you are maintaining the stock
Posted by	BlackholeZ on November 25, 2015 at 1:11 PM
	This message has been viewed 376 times.
In Reply To	whichever one most closely preserves the stock front/rear posted by LJZTT on November 25, 2015 at 07:54 AM
Message	tire sizes and weight distribution. I'm running the same size tires front and rear, so my brake balance will be a little different. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Advise Needed On Choosing AP Racing Bake kit for the z? - zxnazx(tt) 21:14:21 11/24/15 Re: Advise Needed On Choosing AP Racing Bake kit for the z? - Bigwill837 00:34:40 11/25/15 I'd send them back. The brake fluid will eventually - not4resaleZ 09:34:08 11/25/15 I have never seen any specs on the proportioning - LJZTT 11:04:34 11/25/15 AP1120. But buy it from a vendor like IPP that can lean on - MixManMash 03:47:47 11/25/15 whichever one most closely preserves the stock front/rear - LJZTT 07:54:52 11/25/15 Braking balance/bias - Bigwill837 08:29:11 11/25/15 I'd say that no one can beat Brembo's aftermarket kits - not4resaleZ 09:42:52 11/25/15 and you base this conclusion on...........nothing - LJZTT 10:33:13 11/25/15 A lot of it is from the attached link. - not4resaleZ 10:51:28 11/25/15 .............lol - LJZTT 14:45:39 11/25/15 Another couple of things to keep in mind. Brembo - not4resaleZ 10:38:24 11/25/15 lol, you should stop, you're clearly clueless - LJZTT 10:48:08 11/25/15 Your little calculator doesnt really take into account - not4resaleZ 11:05:12 11/25/15 maybe you should try reading, numbnuts - LJZTT 14:37:08 11/25/15 the author only talks about the most basic things that - not4resaleZ 23:33:56 11/25/15 . (n/m) - LJZTT 07:55:29 11/27/15 What are your qualifications? (n/m) - not4resaleZ 23:47:05 11/25/15 What are your qualifications? (n/m) - not4resaleZ 23:52:59 11/25/15 not being dumb. It's a pretty low bar, but you're ducking it (n/m) - LJZTT 07:54:58 11/27/15 Without knowing your level of understanding of basic physic - not4resaleZ 22:08:10 11/27/15 oh no no, I got it now.... - LJZTT 12:29:27 11/28/15 What exactly are your qualifications - not4resaleZ 11:10:38 11/25/15 Which do you think would do a better job at stopping a car? - en5 12:23:22 11/25/15 Wider can also increase lateral traction, which could - not4resaleZ 12:53:02 11/25/15 . - LJZTT 14:58:41 11/25/15 Oh, boy. - bartz32tt 15:41:30 11/25/15 I'm addressing usable rear bias. (n/m) - not4resaleZ 09:38:13 11/26/15 You were attributing lateral traction to brake bias - bartz32tt 21:57:05 11/26/15 try stopping hard in a '73 Duster while going around a - not4resaleZ 22:16:12 11/27/15 in other words, running wider tires could allow you to - not4resaleZ 23:00:00 11/27/15 It's not quite as simple as that - BlackholeZ 13:39:16 11/25/15 shhh! they have only just started self-identifying (n/m) - LJZTT 14:38:57 11/25/15 So your wider tires and front BBK are purely for aesthetics? (n/m) - en5 12:32:08 11/26/15 Bingo. (n/m) - MixManMash 18:09:39 11/25/15 I would certainly agree that a lateral increase - en5 12:42:48 11/26/15 Yes it's not exactly as simple, but look at the basics - BlackholeZ 13:59:42 11/27/15 100% agree on compound playing a bigger role, but... - en5 17:18:53 11/27/15 I'm actually going to take a step back and say - en5 20:18:42 11/26/15 Thank you guys, i am leaning towards the 1120 my self - zxnazx(tt) 12:58:10 11/25/15 there is more than one way to skin the - LJZTT 10:21:04 11/25/15 There's a lot more to it than you're considering - BlackholeZ 13:35:29 11/25/15 absolutely, there are so many variables, and that is the - LJZTT 14:41:09 11/25/15 Yes, though that's only if you are maintaining the stock - BlackholeZ 13:11:57 11/25/15 For the black frieday my cost on Stoptech vs AP is same! - zxnazx(tt) 13:54:11 11/25/15 AP 13" - AP1120 (n/m) - MixManMash 05:57:31 11/26/15 i never understood this obsession with the factory brake - michaell32 (FL) 16:19:04 11/25/15 er, it's not an 'obsession' - vorpalZ 17:29:01 11/25/15 im not saying to ignore it. im just saying it shouldnt - michaell32 (FL) 17:40:39 11/25/15 Er... there is tons of data... read below (n/m) - vorpalZ 17:50:00 11/25/15 there are a lot of calculations and theories but no - michaell32 (FL) 18:12:19 11/25/15 there is no argument - LJZTT 16:06:43 11/26/15 from Stoptech... - vorpalZ 17:48:16 11/25/15 Thanks for all Feedback! Went with AP! (n/m) - zxnazx(tt) 18:00:14 11/25/15 ^ doesn't even know what he bought (n/m) - LJZTT 16:08:54 11/26/15 I have the 1100 kit and have no complaints other than - Evan(CA) 20:14:36 11/26/15 Went with two piece rotor 13.5 disk with six piston front (n/m) - zxnazx(tt) 13:28:12 11/27/15
Post a Followup	You cannot reply to this message because you are not logged in.