Subject	Re: I used velcro on mine.
Posted by	russ29 on November 20, 2015 at 11:15 AM
	This message has been viewed 409 times.
In Reply To	I used velcro on mine. (n/m) posted by shiers69 on November 20, 2015 at 10:23 AM
Message	I had velcro but the heat inside of the car started to melt the glue on the back of the velcro and made a mess. I finally replaced the bar and clips with a new one.
Follow Ups	Bar cover across the radio bezel - JMartz 09:01:27 11/19/15 That's it. - Bernie (NoVA) 09:17:31 11/19/15 You need to use trim tools to remove without damage - ttsmokin 09:55:08 11/19/15 Best place to buy these trim tools? (n/m) - OverZealous (CT) 20:44:14 11/19/15 got mine form here..Canadian "harbour freight" - itsa300zx 08:11:24 11/20/15 That's helpful. Got me thinking of options. Thanks! (n/m) - OverZealous (CT) 07:57:18 11/21/15 there are actually two very thin slot under each steel - itsa300zx 14:19:19 11/19/15 I've attached mine with a couple of adhesive velcro pads - Gordo 93TT Daytona 14:40:08 11/19/15 Did the same thing - Z32CheekiBreeki 17:01:39 11/19/15 The key is the shape of the metal springs - OverZealous (CT) 21:01:36 11/19/15 take the clips off and replace with double sided tape. (n/m) - BannonZ 22:17:27 11/19/15 I used velcro on mine. (n/m) - shiers69 10:23:20 11/20/15 Re: I used velcro on mine. - russ29 11:15:04 11/20/15 You used to be able to buy just the metal spring clips - RICH1 09:58:43 11/20/15 Unfortunately, it is the plastic tabs that fail. - JMartz 11:05:17 11/20/15
Post a Followup	You cannot reply to this message because you are not logged in.