Subject	Re: No comment about fitment on Jspec?
Posted by	Dallas DamonZ on November 08, 2015 at 10:19 PM
	This message has been viewed 265 times.
In Reply To	No comment about fitment on Jspec? (n/m) posted by BlackholeZ on November 08, 2015 at 01:18 PM
Message	Haven't tried but would like to know. Looking at pics I think the arm would work, but not sure about how the loop would set with the angle at the bottom of the radiator opening might interfere. Later When was the last time you *really* did something with your Z to call yourself a Z enthusiast? Member #1 PETZ
Follow Ups	300 Degree New Product Announcement - Dallas DamonZ 15:04:32 11/05/15 hmmmmm... I dunno - vorpalZ 17:04:08 11/05/15 any photos on the weld location? (n/m) - njz 17:24:31 11/05/15 Re: any photos on the weld location? - Dallas DamonZ 18:08:05 11/05/15 it's pretty obvious when you hold it into position - vorpalZ 19:21:52 11/05/15 no physics charts, no care (n/m) - LJZTT 19:54:26 11/05/15 bcuz...race car. (n/m) - Bernie (NoVA) 19:03:45 11/05/15 I'll pass (n/m) - Stanky 20:10:43 11/05/15 I don't mean to be a dick - Goldchocobo 21:52:35 11/05/15 i would get this for my race car (n/m) - ztunerz 09:28:58 11/06/15 I also don't like that it is welded... (n/m) - -Grimm- 15:48:20 11/06/15 hmmm - Jason300zxTT 18:03:17 11/06/15 Re: hmmm - Dallas DamonZ 18:55:28 11/06/15 Damon, I have a question - ZXRider 19:05:10 11/06/15 Washers (n/m) - Dallas DamonZ 21:15:19 11/06/15 Great mounts for a Laasserrr too. :-) (n/m) - DAYTONAZ 07:47:15 11/08/15 Stick a GoPro on the inboard side. (n/m) - Dallas DamonZ 10:08:17 11/08/15 No comment about fitment on Jspec? (n/m) - BlackholeZ 13:18:37 11/08/15 Re: No comment about fitment on Jspec? - Dallas DamonZ 22:19:46 11/08/15 True. Maybe have to stick further out to not rub. (n/m) - BlackholeZ 21:41:52 11/09/15
Post a Followup	You cannot reply to this message because you are not logged in.