Subject	I'll pass (n/m)
Posted by	Stanky on November 05, 2015 at 8:10 PM
	This message has been viewed 286 times.
In Reply To	300 Degree New Product Announcement posted by Dallas DamonZ on November 05, 2015 at 03:04 PM
Message
Follow Ups	300 Degree New Product Announcement - Dallas DamonZ 15:04:32 11/05/15 hmmmmm... I dunno - vorpalZ 17:04:08 11/05/15 any photos on the weld location? (n/m) - njz 17:24:31 11/05/15 Re: any photos on the weld location? - Dallas DamonZ 18:08:05 11/05/15 it's pretty obvious when you hold it into position - vorpalZ 19:21:52 11/05/15 no physics charts, no care (n/m) - LJZTT 19:54:26 11/05/15 bcuz...race car. (n/m) - Bernie (NoVA) 19:03:45 11/05/15 I'll pass (n/m) - Stanky 20:10:43 11/05/15 I don't mean to be a dick - Goldchocobo 21:52:35 11/05/15 i would get this for my race car (n/m) - ztunerz 09:28:58 11/06/15 I also don't like that it is welded... (n/m) - -Grimm- 15:48:20 11/06/15 hmmm - Jason300zxTT 18:03:17 11/06/15 Re: hmmm - Dallas DamonZ 18:55:28 11/06/15 Damon, I have a question - ZXRider 19:05:10 11/06/15 Washers (n/m) - Dallas DamonZ 21:15:19 11/06/15 Great mounts for a Laasserrr too. :-) (n/m) - DAYTONAZ 07:47:15 11/08/15 Stick a GoPro on the inboard side. (n/m) - Dallas DamonZ 10:08:17 11/08/15 No comment about fitment on Jspec? (n/m) - BlackholeZ 13:18:37 11/08/15 Re: No comment about fitment on Jspec? - Dallas DamonZ 22:19:46 11/08/15 True. Maybe have to stick further out to not rub. (n/m) - BlackholeZ 21:41:52 11/09/15
Post a Followup	You cannot reply to this message because you are not logged in.