Subject	Since it's a simple piece of sheet metal that's
Posted by	Goldchocobo on November 02, 2015 at 6:39 PM
	This message has been viewed 290 times.
In Reply To	Rot issue posted by Brad(RI) on November 01, 2015 at 07:14 PM
Message	covered by the rear bumper skin, I would cut it out and weld in replacement high carbon sheet metal formed to the same shape. It's hidden, anyway, and any imperfections will be hidden. I've done it plenty before, it's not hard.
Follow Ups	Rot issue - Brad(RI) 19:14:38 11/01/15 Don't know but much appreciate the post. (n/m) - OverZealous (CT) 21:40:41 11/01/15 Just a tip, swap out factory screws/hardware for stainless. - bartz32tt 21:51:30 11/01/15 I would not use dissimilar metal in that area - Brad(RI) 18:46:30 11/02/15 No problems to report. - bartz32tt 23:46:17 11/02/15 I would not use dissimilar metal in that area - Brad(RI) 19:37:15 11/02/15 Re: Rot issue - shiers69 08:27:58 11/02/15 Lol (n/m) - Drk93TT 18:18:25 11/02/15 I'm glad somebody understood it (n/m) - shiers69 18:31:07 11/02/15 Yep. Rusty spooooons (n/m) - Drk93TT 18:46:53 11/02/15 What's not to understand about salad fingers!? (n/m) - -Grimm- 00:30:18 11/03/15 Link inside - 96300NAZ 08:54:22 11/02/15 Thanks, we are going to try that extension (n/m) - Brad(RI) 18:38:44 11/02/15 Its number 4 . . . i just did this on my z - toykoz32 21:24:50 11/03/15 here. - slayer fan 13:13:01 11/02/15 Re: Rot issue - Dallas DamonZ 14:57:26 11/02/15 Thanks Damon I will let you know - Brad(RI) 18:41:19 11/02/15 Since it's a simple piece of sheet metal that's - Goldchocobo 18:39:18 11/02/15 The inner part of it is what we need as well - Brad(RI) 18:43:08 11/02/15 Inner part is probably part of the rear floor. (n/m) - toykoz32 21:26:28 11/03/15 looked in a few estimate programs and came up with: - toykoz32 21:54:45 11/03/15
Post a Followup	You cannot reply to this message because you are not logged in.