Subject	I'm glad somebody understood it (n/m)
Posted by	shiers69 on November 02, 2015 at 6:31 PM
	This message has been viewed 279 times.
In Reply To	Lol (n/m) posted by Drk93TT on November 02, 2015 at 06:18 PM
Message
Follow Ups	Rot issue - Brad(RI) 19:14:38 11/01/15 Don't know but much appreciate the post. (n/m) - OverZealous (CT) 21:40:41 11/01/15 Just a tip, swap out factory screws/hardware for stainless. - bartz32tt 21:51:30 11/01/15 I would not use dissimilar metal in that area - Brad(RI) 18:46:30 11/02/15 No problems to report. - bartz32tt 23:46:17 11/02/15 I would not use dissimilar metal in that area - Brad(RI) 19:37:15 11/02/15 Re: Rot issue - shiers69 08:27:58 11/02/15 Lol (n/m) - Drk93TT 18:18:25 11/02/15 I'm glad somebody understood it (n/m) - shiers69 18:31:07 11/02/15 Yep. Rusty spooooons (n/m) - Drk93TT 18:46:53 11/02/15 What's not to understand about salad fingers!? (n/m) - -Grimm- 00:30:18 11/03/15 Link inside - 96300NAZ 08:54:22 11/02/15 Thanks, we are going to try that extension (n/m) - Brad(RI) 18:38:44 11/02/15 Its number 4 . . . i just did this on my z - toykoz32 21:24:50 11/03/15 here. - slayer fan 13:13:01 11/02/15 Re: Rot issue - Dallas DamonZ 14:57:26 11/02/15 Thanks Damon I will let you know - Brad(RI) 18:41:19 11/02/15 Since it's a simple piece of sheet metal that's - Goldchocobo 18:39:18 11/02/15 The inner part of it is what we need as well - Brad(RI) 18:43:08 11/02/15 Inner part is probably part of the rear floor. (n/m) - toykoz32 21:26:28 11/03/15 looked in a few estimate programs and came up with: - toykoz32 21:54:45 11/03/15
Post a Followup	You cannot reply to this message because you are not logged in.