Subject	Rot issue
Posted by	Brad(RI) on November 01, 2015 at 7:14 PM
	This message has been viewed 820 times.
Message	As some may know, I daily drive my Zs for 200,000+ miles each. Unfortunately, living in the North East, I have a couple rot issues that right now we don't have a great solution for. The problem is the right rear quarter, the area under the rear fascia. We cant find factory panels or patches for this area and the inner part of it also is need. This is the part that has the little tang that the rear fascia screws to. If anyone knows of a source or has a parts car they would not mind cutting this part off please let me know, Thanks.
Follow Ups	Rot issue - Brad(RI) 19:14:38 11/01/15 Don't know but much appreciate the post. (n/m) - OverZealous (CT) 21:40:41 11/01/15 Just a tip, swap out factory screws/hardware for stainless. - bartz32tt 21:51:30 11/01/15 I would not use dissimilar metal in that area - Brad(RI) 18:46:30 11/02/15 No problems to report. - bartz32tt 23:46:17 11/02/15 I would not use dissimilar metal in that area - Brad(RI) 19:37:15 11/02/15 Re: Rot issue - shiers69 08:27:58 11/02/15 Lol (n/m) - Drk93TT 18:18:25 11/02/15 I'm glad somebody understood it (n/m) - shiers69 18:31:07 11/02/15 Yep. Rusty spooooons (n/m) - Drk93TT 18:46:53 11/02/15 What's not to understand about salad fingers!? (n/m) - -Grimm- 00:30:18 11/03/15 Link inside - 96300NAZ 08:54:22 11/02/15 Thanks, we are going to try that extension (n/m) - Brad(RI) 18:38:44 11/02/15 Its number 4 . . . i just did this on my z - toykoz32 21:24:50 11/03/15 here. - slayer fan 13:13:01 11/02/15 Re: Rot issue - Dallas DamonZ 14:57:26 11/02/15 Thanks Damon I will let you know - Brad(RI) 18:41:19 11/02/15 Since it's a simple piece of sheet metal that's - Goldchocobo 18:39:18 11/02/15 The inner part of it is what we need as well - Brad(RI) 18:43:08 11/02/15 Inner part is probably part of the rear floor. (n/m) - toykoz32 21:26:28 11/03/15 looked in a few estimate programs and came up with: - toykoz32 21:54:45 11/03/15
Post a Followup	You cannot reply to this message because you are not logged in.