Subject	How do you get to the PS WG?
Posted by	evan_aggie on October 21, 2015 at 10:12 PM
	This message has been viewed 406 times.
In Reply To	Again, your set up is in-correct.... posted by Greg D. (Specialty-Z) on October 21, 2015 at 07:49 PM
Message	I had modified the factory rod and installed (via threading) a threaded end. I suppose I could try to fish my fat hand up along there and see if I couldn't twist the rod to tighten it in place. There is no way in hell I'm getting that little mini-C clip off the end of the WG rod...and even if i do, I doubt I'll be able to reinstall it. Will that rod spin the diaphragm internally if the end is still connected? I'm not sure if that makes sense without drawing a picture.
Follow Ups	My max boost is 15 psi...or not? - evan_aggie 10:20:19 10/21/15 That may be boost creep - BlackholeZ 11:28:38 10/21/15 My boost controller seems spot on and works well...below 15. (n/m) - evan_aggie 11:48:30 10/21/15 Your waste gates should be set at the lowest desired psi. - bartz32tt 14:02:38 10/21/15 Your adjustment is creating the issues..... - Greg D. (Specialty-Z) 14:36:19 10/21/15 Greg, you programmed my Greddy unit. - evan_aggie 15:33:00 10/21/15 To be clear - I'm actually quite happy with how the - evan_aggie 15:36:44 10/21/15 20 psi spikes on pump gas seems like a problem.. (n/m) - Boosted1 19:35:52 10/21/15 Again, your set up is in-correct.... - Greg D. (Specialty-Z) 19:49:12 10/21/15 How do you get to the PS WG? - evan_aggie 22:12:22 10/21/15 Evan, email or call Dane he might be able to give you some - Krazyd27(Houston) 11:17:59 10/22/15
Post a Followup	You cannot reply to this message because you are not logged in.