TwinTurbo.NET: Nissan 300ZX forum - Yes, I know big intercoolers and piping would help :-P
People Seeking Info
 
   


     
Subject Yes, I know big intercoolers and piping would help :-P
     
Posted by BlackholeZ on October 18, 2015 at 12:40 PM
  This message has been viewed 401 times.
     
In Reply To Re: Finally got on the dyno posted by Bigwill837 on October 18, 2015 at 11:52 AM
     
Message I'm basically having to mod as I can afford, and attacking the biggest targets first. I'm running Ash's built in EBC, which is nice because I don't run full boost at autocross. I'd like a proper EBC, but I don't come across an extra $600 very often.

I wish that he had started the pull at 2k rpm. I've got ~5psi and building at 2500 if I start at 2k. Right now I'm modding mostly for response, because that's what helps the most at autox, and I have enough trouble keeping my existing power in check anyway. I am looking at the RE71R for my next set of tires though.

Overall though, I'm a student, and really focusing on keeping my Z reliable. It's my only car, and I can't afford to blow it up trying to push it a little further without having everything in place to do it properly.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.