Message |
Not sure if I did something wrong when installing, but the heims squeak a lot. I had the SPL tension rods, but swapped back in stock rods due to how embarrassingly loud the SPL units were.
You do not have to remove the rear knuckles to remove the ball joints. Just rent a ball joint press from Autozone and do it on the car.
Also, some advice. Take the measurement shown below prior to removing the HICAS tie rods. It will give you a baseline to set up your new links.
P.S. when you take that measurement, please post the number. I want to compare with what I have.
|
|