| Message |
I use to work at a body shop. I'm not talking new can, I am talking old school muscle car. I am not going to say it will not turnout good because it probably will, but the shop that I worked at that wouldn't fly. It just goes to show quality take a back seat to cost! It could have been a nice widebody back half car. It is not center front to back, or around the circumfence around the tire. You might want to take a step back and look at the body work from more than one angle. There not suppose to be flat spots in circle unless you are a two year old just learning to trace. Then the two inch plus over hang of the body lower rear fender, expect rock to kickup because of poor planning! Good luck! Can't wait to see unedited picture, while you are at it might as well mold the rear bumper gap flush to the rest on the bodyline.
|
 |
