TwinTurbo.NET: Nissan 300ZX forum - Thanks!
People Seeking Info
 
   


     
Subject Thanks!
     
Posted by Jayru on July 03, 2015 at 11:05 PM
  This message has been viewed 445 times.
     
In Reply To Nice write-up! posted by OverZealous (CT) on July 03, 2015 at 09:33 PM
     
Message Yeah, the pic was of a new custom feed line I had made by ATP Turbo (with new USA machined steel restrictors to match). I just didn't trust the quality of the ones sold by Z32 vendors (as they all basically looked the same), and I didn't want to have to do the job again down the road.

It was the driver side that leaked, and I had to pull the motor to get to it. My original line came from CZP, and leaked where the line fitting sealed against the turbo fitting.

It was fine under normal driving conditions, but under high oil pressure/upper RPM (like when winding the car out all weekend at the Glen), it would piss out the upper seal. I had to make some small modifications to get the larger ATP fittings to work, but it was worth it, as the stuff is quality, with Teflon seals and all.

93 2+2 Twin Turbo Track Build - jsworks.org for more info!

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.