Subject	Actually not bad at all I followed this guide from aus300zx
Posted by	YlwPrlZTT on June 02, 2015 at 5:42 PM
	This message has been viewed 314 times.
In Reply To	Good stuff, how was the ptu sub-harness delete?? (n/m) posted by FrozTTy on June 02, 2015 at 05:39 PM
Message	website, it's just like he says, wire by wire until all are done. PTU Sub-harness delete
Follow Ups	Thank you all that helped me get my Z back together. - YlwPrlZTT 16:12:23 06/02/15 Well done....Enjoy (n/m) - ttz'in (norcal) 16:49:09 06/02/15 Nice work, looks clean. (n/m) - CameronSF 17:02:26 06/02/15 what brand is that yellow hose you are running for vacuum? (n/m) - diamond20601 17:12:52 06/02/15 got them from ebay, link inside, they seem decent quality - YlwPrlZTT 17:40:18 06/02/15 Awesome! Just double check everything in a few days - MixManMash 17:18:15 06/02/15 good job!!! I recommend zip tie the ends of those hoses. (n/m) - itsa300zx 17:19:10 06/02/15 Good stuff, how was the ptu sub-harness delete?? (n/m) - FrozTTy 17:39:00 06/02/15 Actually not bad at all I followed this guide from aus300zx - YlwPrlZTT 17:42:31 06/02/15 Go enjoy it! :) (n/m) - Zuberman 02:31:05 06/03/15 Nice job! Looks sharp. - ConVerTT 08:30:02 06/03/15 Looks like a water temp sensor for an aftermarket gauge. (n/m) - ZXRider 10:59:46 06/03/15 Yes, that's all it is. (n/m) - YlwPrlZTT 13:36:11 06/03/15 Which parts of the EGR? - Stokens (AR) 16:22:39 06/04/15
Post a Followup	You cannot reply to this message because you are not logged in.