Subject	Nope, just the OEM seal and an extra dose of patience :) (n/m)
Posted by	ThisIsSparTTa on June 01, 2015 at 8:19 AM
	This message has been viewed 293 times.
In Reply To	Did you use a smaller seal to accommodate the big sleeve? posted by OverZealous (CT) on May 31, 2015 at 08:51 PM
Message
Follow Ups	Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal - OverZealous (CT) 21:41:59 05/28/15 I'd say you're too overzealous to use such a thing (n/m) - spicyZ 21:50:43 05/28/15 we have had some RMS sealing issues at the shop lately - Dane (Houston) 09:17:51 05/29/15 Re: we have had some RMS sealing issues at the shop lately - OverZealous (CT) 09:45:36 05/30/15 You're saying it will stick out to where the flywheel - BlackholeZ 00:15:17 05/29/15 How did you lap the smaller sleeve? - OverZealous (CT) 07:04:07 05/29/15 I did it by hand with sandpaper and an old surface table - BlackholeZ 12:37:40 05/29/15 I've installed the 99331 SKF Speedi Sleeve, it will work: - ThisIsSparTTa 12:30:44 05/29/15 Thank you for the post - 99331 SKF Speedi-Sleeve Updatez - OverZealous (CT) 23:09:32 05/29/15 Please reply and let us know how this is going and what the - Zuberman 08:34:44 05/31/15 Re: Thank you for the post - 99331 SKF Speedi-Sleeve Updatez - ThisIsSparTTa 12:13:55 05/31/15 Did you use a smaller seal to accommodate the big sleeve? - OverZealous (CT) 20:51:03 05/31/15 Nope, just the OEM seal and an extra dose of patience :) (n/m) - ThisIsSparTTa 08:19:36 06/01/15 Re: Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal - MaxxAction 21:43:49 05/30/15 Appreciate the post! (n/m) - OverZealous (CT) 20:45:07 05/31/15
Post a Followup	You cannot reply to this message because you are not logged in.