TwinTurbo.NET: Nissan 300ZX forum - Appreciate the post! (n/m)
Subject
Appreciate the post! (n/m)
Posted by
OverZealous (CT)
on May 31, 2015 at 8:45 PM
This message has been viewed
304
times.
In Reply To
Re: Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal
posted by MaxxAction
on May 30, 2015 at 09:43 PM
Message
Follow Ups
Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal
-
OverZealous (CT)
21:41:59 05/28/15
I'd say you're too overzealous to use such a thing (n/m)
-
spicyZ
21:50:43 05/28/15
we have had some RMS sealing issues at the shop lately
-
Dane (Houston)
09:17:51 05/29/15
Re: we have had some RMS sealing issues at the shop lately
-
OverZealous (CT)
09:45:36 05/30/15
You're saying it will stick out to where the flywheel
-
BlackholeZ
00:15:17 05/29/15
How did you lap the smaller sleeve?
-
OverZealous (CT)
07:04:07 05/29/15
I did it by hand with sandpaper and an old surface table
-
BlackholeZ
12:37:40 05/29/15
I've installed the 99331 SKF Speedi Sleeve, it will work:
-
ThisIsSparTTa
12:30:44 05/29/15
Thank you for the post - 99331 SKF Speedi-Sleeve Updatez
-
OverZealous (CT)
23:09:32 05/29/15
Please reply and let us know how this is going and what the
-
Zuberman
08:34:44 05/31/15
Re: Thank you for the post - 99331 SKF Speedi-Sleeve Updatez
-
ThisIsSparTTa
12:13:55 05/31/15
Did you use a smaller seal to accommodate the big sleeve?
-
OverZealous (CT)
20:51:03 05/31/15
Nope, just the OEM seal and an extra dose of patience :) (n/m)
-
ThisIsSparTTa
08:19:36 06/01/15
Re: Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal
-
MaxxAction
21:43:49 05/30/15
Appreciate the post! (n/m) -
OverZealous (CT)
20:45:07 05/31/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.