TwinTurbo.NET: Nissan 300ZX forum - Was that a warm compression test?
Subject
Was that a warm compression test?
Posted by
Red Hawk (CO)
on May 29, 2015 at 4:02 PM
This message has been viewed
279
times.
In Reply To
Time for a rebuild?
posted by platinumist
on May 28, 2015 at 08:47 PM
Message
The numbers are consistent, just low. A cold motor can swing the numbers pretty far.
Follow Ups
Time for a rebuild?
-
platinumist
20:47:12 05/28/15
I'm no expert but this is my honest opinion...
-
puchy
22:16:19 05/28/15
Re: I'm no expert but this is my honest opinion...
-
platinumist
11:00:45 05/29/15
OEM head studs should be ok at that power level
-
puchy
12:02:56 05/29/15
OEM Head Bolts are fine even at 800HP+ power levels.
-
MixManMash
10:19:57 05/30/15
2560's suck. less top end and same lag as 2860's (n/m)
-
Antihero
00:09:53 06/01/15
Was that a warm compression test? -
Red Hawk (CO)
16:02:16 05/29/15
Re: Was that a warm compression test?
-
platinumist
16:27:47 05/29/15
eh...not in my experience
-
aliaZ
14:53:59 05/30/15
I would recommend going with forged internals for the bottom
-
MixManMash
10:30:23 05/30/15
Re: I would recommend going with forged internals for the bottom
-
platinumist
14:39:24 05/31/15
You could just get a chip burned with your custom tune.
-
MixManMash
20:35:15 05/31/15
Will my 550cc injectors hold me back?
-
platinumist
14:52:29 05/31/15
About 550hp. However, those 550s you have are not very good
-
MixManMash
20:37:03 05/31/15
Yeah I know they aren't great,
-
platinumist
00:04:21 06/01/15
I'd do a leak down test
-
aliaZ
14:58:33 05/30/15
Agreed. (n/m)
-
Bernie (NoVA)
19:39:06 05/30/15
Very good point and I agree. (n/m)
-
MixManMash
10:54:19 05/31/15
Good point.
-
platinumist
14:42:43 05/31/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.