Subject	I did it by hand with sandpaper and an old surface table
Posted by	BlackholeZ on May 29, 2015 at 12:37 PM
	This message has been viewed 445 times.
In Reply To	How did you lap the smaller sleeve? posted by OverZealous (CT) on May 29, 2015 at 07:04 AM
Message	If you've only got 3 thou to go you could probably make it happen just being gentle. Start with 600 to 1000 grit sandpaper on a flat surface and use some kind of lubricant. Use very light pressure distributed around the ring because the edge will want to dig in and make figure 8 shapes. Check your progress regularly and at multiple points around the ring. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal - OverZealous (CT) 21:41:59 05/28/15 I'd say you're too overzealous to use such a thing (n/m) - spicyZ 21:50:43 05/28/15 we have had some RMS sealing issues at the shop lately - Dane (Houston) 09:17:51 05/29/15 Re: we have had some RMS sealing issues at the shop lately - OverZealous (CT) 09:45:36 05/30/15 You're saying it will stick out to where the flywheel - BlackholeZ 00:15:17 05/29/15 How did you lap the smaller sleeve? - OverZealous (CT) 07:04:07 05/29/15 I did it by hand with sandpaper and an old surface table - BlackholeZ 12:37:40 05/29/15 I've installed the 99331 SKF Speedi Sleeve, it will work: - ThisIsSparTTa 12:30:44 05/29/15 Thank you for the post - 99331 SKF Speedi-Sleeve Updatez - OverZealous (CT) 23:09:32 05/29/15 Please reply and let us know how this is going and what the - Zuberman 08:34:44 05/31/15 Re: Thank you for the post - 99331 SKF Speedi-Sleeve Updatez - ThisIsSparTTa 12:13:55 05/31/15 Did you use a smaller seal to accommodate the big sleeve? - OverZealous (CT) 20:51:03 05/31/15 Nope, just the OEM seal and an extra dose of patience :) (n/m) - ThisIsSparTTa 08:19:36 06/01/15 Re: Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal - MaxxAction 21:43:49 05/30/15 Appreciate the post! (n/m) - OverZealous (CT) 20:45:07 05/31/15
Post a Followup	You cannot reply to this message because you are not logged in.