TwinTurbo.NET: Nissan 300ZX forum - Re: I'm no expert but this is my honest opinion...
Subject
Re: I'm no expert but this is my honest opinion...
Posted by
platinumist
on May 29, 2015 at 11:00 AM
This message has been viewed
235
times.
In Reply To
I'm no expert but this is my honest opinion...
posted by puchy
on May 28, 2015 at 10:16 PM
Message
Yes, throttle was open. The GT2560s really hit my price point, and 450whp sounds good to me. I have heard that OEM head gaskets are pretty stout so I'll stick with that. I'm considering just getting forged pistons now. OEM head studs should be ok?
Follow Ups
Time for a rebuild?
-
platinumist
20:47:12 05/28/15
I'm no expert but this is my honest opinion...
-
puchy
22:16:19 05/28/15
Re: I'm no expert but this is my honest opinion... -
platinumist
11:00:45 05/29/15
OEM head studs should be ok at that power level
-
puchy
12:02:56 05/29/15
OEM Head Bolts are fine even at 800HP+ power levels.
-
MixManMash
10:19:57 05/30/15
2560's suck. less top end and same lag as 2860's (n/m)
-
Antihero
00:09:53 06/01/15
Was that a warm compression test?
-
Red Hawk (CO)
16:02:16 05/29/15
Re: Was that a warm compression test?
-
platinumist
16:27:47 05/29/15
eh...not in my experience
-
aliaZ
14:53:59 05/30/15
I would recommend going with forged internals for the bottom
-
MixManMash
10:30:23 05/30/15
Re: I would recommend going with forged internals for the bottom
-
platinumist
14:39:24 05/31/15
You could just get a chip burned with your custom tune.
-
MixManMash
20:35:15 05/31/15
Will my 550cc injectors hold me back?
-
platinumist
14:52:29 05/31/15
About 550hp. However, those 550s you have are not very good
-
MixManMash
20:37:03 05/31/15
Yeah I know they aren't great,
-
platinumist
00:04:21 06/01/15
I'd do a leak down test
-
aliaZ
14:58:33 05/30/15
Agreed. (n/m)
-
Bernie (NoVA)
19:39:06 05/30/15
Very good point and I agree. (n/m)
-
MixManMash
10:54:19 05/31/15
Good point.
-
platinumist
14:42:43 05/31/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.