TwinTurbo.NET: Nissan 300ZX forum - we have had some RMS sealing issues at the shop lately
Subject
we have had some RMS sealing issues at the shop lately
Posted by
Dane (Houston)
on May 29, 2015 at 9:17 AM
This message has been viewed
433
times.
In Reply To
I'd say you're too overzealous to use such a thing (n/m)
posted by spicyZ
on May 28, 2015 at 09:50 PM
Message
with rebuilt engines. possibly because the the back of the crank is being turned down to take out the RMS wear.
Follow Ups
Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal
-
OverZealous (CT)
21:41:59 05/28/15
I'd say you're too overzealous to use such a thing (n/m)
-
spicyZ
21:50:43 05/28/15
we have had some RMS sealing issues at the shop lately -
Dane (Houston)
09:17:51 05/29/15
Re: we have had some RMS sealing issues at the shop lately
-
OverZealous (CT)
09:45:36 05/30/15
You're saying it will stick out to where the flywheel
-
BlackholeZ
00:15:17 05/29/15
How did you lap the smaller sleeve?
-
OverZealous (CT)
07:04:07 05/29/15
I did it by hand with sandpaper and an old surface table
-
BlackholeZ
12:37:40 05/29/15
I've installed the 99331 SKF Speedi Sleeve, it will work:
-
ThisIsSparTTa
12:30:44 05/29/15
Thank you for the post - 99331 SKF Speedi-Sleeve Updatez
-
OverZealous (CT)
23:09:32 05/29/15
Please reply and let us know how this is going and what the
-
Zuberman
08:34:44 05/31/15
Re: Thank you for the post - 99331 SKF Speedi-Sleeve Updatez
-
ThisIsSparTTa
12:13:55 05/31/15
Did you use a smaller seal to accommodate the big sleeve?
-
OverZealous (CT)
20:51:03 05/31/15
Nope, just the OEM seal and an extra dose of patience :) (n/m)
-
ThisIsSparTTa
08:19:36 06/01/15
Re: Installing SKF Speedi-Sleeve from NAPA on Rear Crank 4 Seal
-
MaxxAction
21:43:49 05/30/15
Appreciate the post! (n/m)
-
OverZealous (CT)
20:45:07 05/31/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.