Subject	^ Agree ^ As Dan points out removing outer
Posted by	ttz'in (norcal) on May 26, 2015 at 4:13 PM
	This message has been viewed 292 times.
In Reply To	Pulling the outer tie rod from the knuckle isn't that hard posted by BlackholeZ on May 26, 2015 at 02:31 PM
Message	tie rod end isn't that difficult. Before loosening tie rod lock nut a 1/2 turn, wrap a piece of duct tape on exposed tie rod threads to mark position. Spray penetrant where tie rod presses into knuckle, loosen bolt & "smack" side surface area of knuckle with hammer.
Follow Ups	Just the tie-rod dust-boot: the write-ups I found went into - Zuberman 12:36:05 05/26/15 Great writup and pics! - Goldchocobo 14:18:53 05/26/15 Pulling the outer tie rod from the knuckle isn't that hard - BlackholeZ 14:31:52 05/26/15 ^ Agree ^ As Dan points out removing outer - ttz'in (norcal) 16:13:18 05/26/15 I disagree. This didn't work for me. - OverZealous (CT) 20:32:50 05/28/15 tie rod end puller is the correct answer. - Bernie (NoVA) 21:33:32 05/29/15 I think the boots you installed are a bit too long - keep an - Bernie (NoVA) 08:47:09 05/27/15 Could it be the panoramic nature of the pics? - Zuberman 14:08:43 05/27/15 Very true, Nissan does not give them away $$. (n/m) - ttz'in (norcal) 16:18:17 05/27/15
Post a Followup	You cannot reply to this message because you are not logged in.