Subject	Pulling the outer tie rod from the knuckle isn't that hard
Posted by	BlackholeZ on May 26, 2015 at 2:31 PM
	This message has been viewed 304 times.
In Reply To	Just the tie-rod dust-boot: the write-ups I found went into posted by Zuberman on May 26, 2015 at 12:36 PM
Message	Unbolt it and smack it with a hammer, then you can just spin it off. Not a bad write up though, just needs to posted in the tech forum... -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Just the tie-rod dust-boot: the write-ups I found went into - Zuberman 12:36:05 05/26/15 Great writup and pics! - Goldchocobo 14:18:53 05/26/15 Pulling the outer tie rod from the knuckle isn't that hard - BlackholeZ 14:31:52 05/26/15 ^ Agree ^ As Dan points out removing outer - ttz'in (norcal) 16:13:18 05/26/15 I disagree. This didn't work for me. - OverZealous (CT) 20:32:50 05/28/15 tie rod end puller is the correct answer. - Bernie (NoVA) 21:33:32 05/29/15 I think the boots you installed are a bit too long - keep an - Bernie (NoVA) 08:47:09 05/27/15 Could it be the panoramic nature of the pics? - Zuberman 14:08:43 05/27/15 Very true, Nissan does not give them away $$. (n/m) - ttz'in (norcal) 16:18:17 05/27/15
Post a Followup	You cannot reply to this message because you are not logged in.