Subject	ran into the same issues.
Posted by	RobZ32 on May 23, 2015 at 3:23 PM
	This message has been viewed 305 times.
In Reply To	Pics of my issues posted by PiotrC70 on May 22, 2015 at 09:53 PM
Message	I just opened the holes a bit more so the screws would go in completely. Rob It's never "DONE", just finished enough to drive :-) - BigTDogg (MA)
Follow Ups	TwinZ rear V2 bumper install issues. - PiotrC70 21:32:28 05/22/15 Pics of my issues - PiotrC70 21:53:34 05/22/15 Re: Pics of my issues - diamond20601 02:49:04 05/23/15 Neither. Bumper has never been replaced. I have a scuff on - PiotrC70 10:47:32 05/23/15 After opening up the two outer holes, and using a flathead - PiotrC70 17:50:35 05/23/15 You may have to do some trimming - DAYTONAZ 18:12:41 05/23/15 Thanks for the tip on dropping the exhaust, it's been so - PiotrC70 17:28:12 05/24/15 Re: Neither. Bumper has never been replaced. I have a scuff on (n/m) - diamond20601 21:46:50 05/24/15 ran into the same issues. - RobZ32 15:23:27 05/23/15 Thanks, I guess, my winter project, any tips, helpful. (n/m) - Z ONLY1 08:50:00 05/26/15
Post a Followup	You cannot reply to this message because you are not logged in.