Subject	Pics of my issues
Posted by	PiotrC70 on May 22, 2015 at 9:53 PM
	This message has been viewed 753 times.
In Reply To	TwinZ rear V2 bumper install issues. posted by PiotrC70 on May 22, 2015 at 09:32 PM
Message	My dad is wanting to open up the two outer mounting points having issues but I'm against this for obvious reasons. Haven't heard of fitment issues despite already having to modify the out support points where the 2 clips hold the bracket in place and holes being off. Far left bolt hole is about 1/4" low despite the bumper side touching the fender. Notice how some of the holes are actually lined up. Second to last bolt is too far left while the far right is also low. Bumper just a bit shy of popping in. My secondary worry is with how tight it went in, that I won't be able to remove the damn thing w/out breaking something. 1993 TT. R.I.P. 09.15.2010
Follow Ups	TwinZ rear V2 bumper install issues. - PiotrC70 21:32:28 05/22/15 Pics of my issues - PiotrC70 21:53:34 05/22/15 Re: Pics of my issues - diamond20601 02:49:04 05/23/15 Neither. Bumper has never been replaced. I have a scuff on - PiotrC70 10:47:32 05/23/15 After opening up the two outer holes, and using a flathead - PiotrC70 17:50:35 05/23/15 You may have to do some trimming - DAYTONAZ 18:12:41 05/23/15 Thanks for the tip on dropping the exhaust, it's been so - PiotrC70 17:28:12 05/24/15 Re: Neither. Bumper has never been replaced. I have a scuff on (n/m) - diamond20601 21:46:50 05/24/15 ran into the same issues. - RobZ32 15:23:27 05/23/15 Thanks, I guess, my winter project, any tips, helpful. (n/m) - Z ONLY1 08:50:00 05/26/15
Post a Followup	You cannot reply to this message because you are not logged in.