|
|
|
|
|
|
Subject |
I used my pry bar to leverage the mount over so the tab |
|
|
|
|
Posted by |
Zuberman on May 19, 2015 at 6:50 AM |
|
|
This message has been viewed 330 times. |
|
|
|
|
In Reply To |
BDE low profile motor mount alignment. posted by Tanley on May 19, 2015 at 06:18 AM |
|
|
|
|
Message |
would drop in the slot by positioning the pry bar between the mount and the frame-rail. Once in position, I got the nut started, then lowered the engine a little, tightened the nut a little, lowered the engine a little, that way the tab descended into the slot. If the mount shifted back I went back to my pry bar. When the tab was caught in the slot, I tightened the nut all the way down. Probably not the way it's supposed to be done, but Mister Unorthodox here, lol.
|
|
|
|
|
Follow Ups |
|
|
|
|
|
Post a Followup |
You cannot reply to this message because you are not logged in.
|
|
|
|
|
|
|
|
|