Has anyone tried bolting their exhaust together and then mounting it under the car? The reason I ask is because I got mine on one pice at a time and there is leaks. Got the bolts on and tight and where the ends are pinched but the center has a small gap. Maybe about as wide as the gasket is thick. It was hard to get it to line up under the car. I believe I was fighting with the heat shield over the h pipe quite a bit. Remove that or bend it? also my rubber hangers over the mufflers are being stretched like no other.
I've got SZ axel back, Z1 h pipe to stock cats. I also bought z1 test pipes but they wouldn't mount to stock precats on account the studs and holes were a little off so they sit in my closet. Is all these problems because z1 parts fitment sucks?
Follow Ups
Any tips/tricks for 3inch exhaust install? - joey4t522:09:24 05/05/15
22:09:24 05/05/15
