Subject	Ah yes, good enough for a tractor :) (n/m)
Posted by	BigTDogg (MA) on May 03, 2015 at 11:17 PM
	This message has been viewed 305 times.
In Reply To	Used common steel rod for head studs. HG blew on startup. posted by LivinTheDream on April 30, 2015 at 09:57 PM
Message
Follow Ups	Just for kicks, name your biggest flub. - rojoloco (VA Beach) 06:19:22 04/30/15 Installed oil pan with the dipstick in. (n/m) - Zvil (FL) 08:28:09 04/30/15 Wasting so much money dating those psycho chicks :( - Zuberman 08:53:09 04/30/15 This! (n/m) - ForceFedTT (SoCal) 18:13:32 05/01/15 Hahaha! Whatever you do don't marry one! (n/m) - OverZealous (CT) 07:03:01 05/03/15 Sooooo lucky each of them rejected me! "Unanswered Prayers" (n/m) - Zuberman 12:14:12 05/03/15 installing manifolds before installing dipstick tube - vorpalZ 08:57:23 04/30/15 Forgot oil restrictors for BB turbo's. (n/m) - SilverZXTT(CO) 09:15:41 04/30/15 Left a timing belt idler stud finger tight. (n/m) - Antihero 09:37:38 04/30/15 installed "good" used turbos, when I knew better:( (n/m) - itsa300zx 09:51:38 04/30/15 installed cooling hard pipes before timing covers.... (n/m) - Rasta420 10:03:21 04/30/15 2nd here. Very frustrating when the liquid gasket was so - Dark Diver 03:46:24 05/01/15 Forgetting to install the knock sensor during a rebuild >_< (n/m) - black300zx 11:04:12 04/30/15 could not find a small piece of paper towel accidently.. - Z ONLY1 11:55:41 04/30/15 Installed a blown motor after replacing all the gaskets and - hunterg 12:33:03 04/30/15 Pulling my engine (2009) when there was nothing wrong w/ it. (n/m) - Inzane 12:52:06 04/30/15 Holy cow! Has it been that long? - MixManMash 20:46:55 04/30/15 Leave him alone, he's insane.... (n/m) - MeatMan 14:03:22 05/01/15 Forgetting how to put my engine back in :-0 (n/m) - ConVerTT 22:44:46 04/30/15 First Place....lapped the entire field. (n/m) - Zuberman 14:20:13 05/01/15 What the heck?!? (n/m) - OverZealous (CT) 07:11:43 05/03/15 not replacing my worn out tires when driving in japan - Adam (Utsunomiya) 13:01:16 04/30/15 rofl!! Low blow. (n/m) - spicyZ 13:34:45 04/30/15 Removing my timing belt before finding TDC (n/m) - Justin (Bayonne, NJ) 13:03:36 04/30/15 Left the wheel lugs finger tight and drove over 100miles - RZturbo 15:17:57 04/30/15 changed oil and forgot drain plug - on my brother's driveway (n/m) - russ29 17:06:36 04/30/15 Did not pre-adjust ride height on SPL coilovers prior to - LJZTT 17:30:10 04/30/15 My other flub: what is the vato reference? lol (n/m) - Zuberman 14:24:43 05/01/15 changed oil & forgot to replace filter on my driveway (n/m) - SeanK (StL) 17:34:44 04/30/15 Ditto...$35 of oil all over the driveway is a sad sight (n/m) - black300zx 20:46:15 04/30/15 Did suspension work and forgot to tighten down wheel lugs... - dTb 21:06:18 04/30/15 forgot the nut for one pulley timing belt - wickdGSXR 21:25:26 04/30/15 Used common steel rod for head studs. HG blew on startup. - LivinTheDream 21:57:31 04/30/15 ^ you win lol (n/m) - Stanky 23:26:43 04/30/15 Ah yes, good enough for a tractor :) (n/m) - BigTDogg (MA) 23:17:36 05/03/15 Re: Just for kicks, name your biggest flub. - mxs666 22:13:44 04/30/15 Needed 4 stitches under my eye - RZturbo 22:25:04 04/30/15 didnt take the 20g I was once offered for the car.. - Stanky 23:32:11 04/30/15 Did timing belt, "saved money" by using the old tensioner - BlackholeZ 01:57:50 05/01/15 Installed hardpipe kit, one of the bolts on the Tbolt clamps - Zsgetyoulaid 02:54:44 05/01/15 Pulled down the tranny on my legs, lying under the car - Dark Diver 04:09:59 05/01/15 Had a rubber glove fall down on the exhaust pipe during - jzack 10:57:50 05/01/15 Did a timing belt change and 60k service once... - JRH(KY) 11:55:36 05/01/15 Started my TT conversion then Bought a house and had 2 kids - Whip 14:57:47 05/01/15 So basically in 20 years. - spicyZ 22:00:33 05/01/15 Forgot to tighten bolt to main alternator power wire - sak01 00:38:30 05/02/15 Oh come on, Bernie! 'fess up! ;-) lol. You, too, Greg :) - Zuberman 01:04:56 05/02/15 Re: Oh come on, Bernie! 'fess up! ;-) lol. You, too, Greg :) - Dallas DamonZ 00:51:56 05/03/15 Yikes! I'm buying new safety glasses today. (n/m) - OverZealous (CT) 07:23:13 05/03/15 WHOA! Totally worth pestering you to share! Great that you - Zuberman 11:48:19 05/03/15 Pretty sure I remember a thread where Bernie - BlackholeZ 23:38:45 05/04/15 No idea what you're talking about... - Bernie (NoVA) 01:22:56 05/05/15 Left my power steering pivot bolt sticking thru the pulley - BigTDogg (MA) 23:15:32 05/03/15
Post a Followup	You cannot reply to this message because you are not logged in.