Subject	Used common steel rod for head studs. HG blew on startup.
Posted by	LivinTheDream on April 30, 2015 at 9:57 PM
	This message has been viewed 318 times.
In Reply To	Just for kicks, name your biggest flub. posted by rojoloco (VA Beach) on April 30, 2015 at 06:19 AM
Message	Also waited until turbos were installed with engine in before connecting wastegate vacuum lines. Started newly installed engine with poorly adjusted throttle bodies and it revved to 3k on startup. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	Just for kicks, name your biggest flub. - rojoloco (VA Beach) 06:19:22 04/30/15 Installed oil pan with the dipstick in. (n/m) - Zvil (FL) 08:28:09 04/30/15 Wasting so much money dating those psycho chicks :( - Zuberman 08:53:09 04/30/15 This! (n/m) - ForceFedTT (SoCal) 18:13:32 05/01/15 Hahaha! Whatever you do don't marry one! (n/m) - OverZealous (CT) 07:03:01 05/03/15 Sooooo lucky each of them rejected me! "Unanswered Prayers" (n/m) - Zuberman 12:14:12 05/03/15 installing manifolds before installing dipstick tube - vorpalZ 08:57:23 04/30/15 Forgot oil restrictors for BB turbo's. (n/m) - SilverZXTT(CO) 09:15:41 04/30/15 Left a timing belt idler stud finger tight. (n/m) - Antihero 09:37:38 04/30/15 installed "good" used turbos, when I knew better:( (n/m) - itsa300zx 09:51:38 04/30/15 installed cooling hard pipes before timing covers.... (n/m) - Rasta420 10:03:21 04/30/15 2nd here. Very frustrating when the liquid gasket was so - Dark Diver 03:46:24 05/01/15 Forgetting to install the knock sensor during a rebuild >_< (n/m) - black300zx 11:04:12 04/30/15 could not find a small piece of paper towel accidently.. - Z ONLY1 11:55:41 04/30/15 Installed a blown motor after replacing all the gaskets and - hunterg 12:33:03 04/30/15 Pulling my engine (2009) when there was nothing wrong w/ it. (n/m) - Inzane 12:52:06 04/30/15 Holy cow! Has it been that long? - MixManMash 20:46:55 04/30/15 Leave him alone, he's insane.... (n/m) - MeatMan 14:03:22 05/01/15 Forgetting how to put my engine back in :-0 (n/m) - ConVerTT 22:44:46 04/30/15 First Place....lapped the entire field. (n/m) - Zuberman 14:20:13 05/01/15 What the heck?!? (n/m) - OverZealous (CT) 07:11:43 05/03/15 not replacing my worn out tires when driving in japan - Adam (Utsunomiya) 13:01:16 04/30/15 rofl!! Low blow. (n/m) - spicyZ 13:34:45 04/30/15 Removing my timing belt before finding TDC (n/m) - Justin (Bayonne, NJ) 13:03:36 04/30/15 Left the wheel lugs finger tight and drove over 100miles - RZturbo 15:17:57 04/30/15 changed oil and forgot drain plug - on my brother's driveway (n/m) - russ29 17:06:36 04/30/15 Did not pre-adjust ride height on SPL coilovers prior to - LJZTT 17:30:10 04/30/15 My other flub: what is the vato reference? lol (n/m) - Zuberman 14:24:43 05/01/15 changed oil & forgot to replace filter on my driveway (n/m) - SeanK (StL) 17:34:44 04/30/15 Ditto...$35 of oil all over the driveway is a sad sight (n/m) - black300zx 20:46:15 04/30/15 Did suspension work and forgot to tighten down wheel lugs... - dTb 21:06:18 04/30/15 forgot the nut for one pulley timing belt - wickdGSXR 21:25:26 04/30/15 Used common steel rod for head studs. HG blew on startup. - LivinTheDream 21:57:31 04/30/15 ^ you win lol (n/m) - Stanky 23:26:43 04/30/15 Ah yes, good enough for a tractor :) (n/m) - BigTDogg (MA) 23:17:36 05/03/15 Re: Just for kicks, name your biggest flub. - mxs666 22:13:44 04/30/15 Needed 4 stitches under my eye - RZturbo 22:25:04 04/30/15 didnt take the 20g I was once offered for the car.. - Stanky 23:32:11 04/30/15 Did timing belt, "saved money" by using the old tensioner - BlackholeZ 01:57:50 05/01/15 Installed hardpipe kit, one of the bolts on the Tbolt clamps - Zsgetyoulaid 02:54:44 05/01/15 Pulled down the tranny on my legs, lying under the car - Dark Diver 04:09:59 05/01/15 Had a rubber glove fall down on the exhaust pipe during - jzack 10:57:50 05/01/15 Did a timing belt change and 60k service once... - JRH(KY) 11:55:36 05/01/15 Started my TT conversion then Bought a house and had 2 kids - Whip 14:57:47 05/01/15 So basically in 20 years. - spicyZ 22:00:33 05/01/15 Forgot to tighten bolt to main alternator power wire - sak01 00:38:30 05/02/15 Oh come on, Bernie! 'fess up! ;-) lol. You, too, Greg :) - Zuberman 01:04:56 05/02/15 Re: Oh come on, Bernie! 'fess up! ;-) lol. You, too, Greg :) - Dallas DamonZ 00:51:56 05/03/15 Yikes! I'm buying new safety glasses today. (n/m) - OverZealous (CT) 07:23:13 05/03/15 WHOA! Totally worth pestering you to share! Great that you - Zuberman 11:48:19 05/03/15 Pretty sure I remember a thread where Bernie - BlackholeZ 23:38:45 05/04/15 No idea what you're talking about... - Bernie (NoVA) 01:22:56 05/05/15 Left my power steering pivot bolt sticking thru the pulley - BigTDogg (MA) 23:15:32 05/03/15
Post a Followup	You cannot reply to this message because you are not logged in.