TwinTurbo.NET: Nissan 300ZX forum - Did suspension work and forgot to tighten down wheel lugs...
Subject
Did suspension work and forgot to tighten down wheel lugs...
Posted by
dTb
on April 30, 2015 at 9:06 PM
This message has been viewed
319
times.
In Reply To
Just for kicks, name your biggest flub.
posted by rojoloco (VA Beach)
on April 30, 2015 at 06:19 AM
Message
luckily figured it out very quickly.
Follow Ups
Just for kicks, name your biggest flub.
-
rojoloco (VA Beach)
06:19:22 04/30/15
Installed oil pan with the dipstick in. (n/m)
-
Zvil (FL)
08:28:09 04/30/15
Wasting so much money dating those psycho chicks :(
-
Zuberman
08:53:09 04/30/15
This! (n/m)
-
ForceFedTT (SoCal)
18:13:32 05/01/15
Hahaha! Whatever you do don't marry one! (n/m)
-
OverZealous (CT)
07:03:01 05/03/15
Sooooo lucky each of them rejected me! "Unanswered Prayers" (n/m)
-
Zuberman
12:14:12 05/03/15
installing manifolds before installing dipstick tube
-
vorpalZ
08:57:23 04/30/15
Forgot oil restrictors for BB turbo's. (n/m)
-
SilverZXTT(CO)
09:15:41 04/30/15
Left a timing belt idler stud finger tight. (n/m)
-
Antihero
09:37:38 04/30/15
installed "good" used turbos, when I knew better:( (n/m)
-
itsa300zx
09:51:38 04/30/15
installed cooling hard pipes before timing covers.... (n/m)
-
Rasta420
10:03:21 04/30/15
2nd here. Very frustrating when the liquid gasket was so
-
Dark Diver
03:46:24 05/01/15
Forgetting to install the knock sensor during a rebuild >_< (n/m)
-
black300zx
11:04:12 04/30/15
could not find a small piece of paper towel accidently..
-
Z ONLY1
11:55:41 04/30/15
Installed a blown motor after replacing all the gaskets and
-
hunterg
12:33:03 04/30/15
Pulling my engine (2009) when there was nothing wrong w/ it. (n/m)
-
Inzane
12:52:06 04/30/15
Holy cow! Has it been that long?
-
MixManMash
20:46:55 04/30/15
Leave him alone, he's insane.... (n/m)
-
MeatMan
14:03:22 05/01/15
Forgetting how to put my engine back in :-0 (n/m)
-
ConVerTT
22:44:46 04/30/15
First Place....lapped the entire field. (n/m)
-
Zuberman
14:20:13 05/01/15
What the heck?!? (n/m)
-
OverZealous (CT)
07:11:43 05/03/15
not replacing my worn out tires when driving in japan
-
Adam (Utsunomiya)
13:01:16 04/30/15
rofl!! Low blow. (n/m)
-
spicyZ
13:34:45 04/30/15
Removing my timing belt before finding TDC (n/m)
-
Justin (Bayonne, NJ)
13:03:36 04/30/15
Left the wheel lugs finger tight and drove over 100miles
-
RZturbo
15:17:57 04/30/15
changed oil and forgot drain plug - on my brother's driveway (n/m)
-
russ29
17:06:36 04/30/15
Did not pre-adjust ride height on SPL coilovers prior to
-
LJZTT
17:30:10 04/30/15
My other flub: what is the vato reference? lol (n/m)
-
Zuberman
14:24:43 05/01/15
changed oil & forgot to replace filter on my driveway (n/m)
-
SeanK (StL)
17:34:44 04/30/15
Ditto...$35 of oil all over the driveway is a sad sight (n/m)
-
black300zx
20:46:15 04/30/15
Did suspension work and forgot to tighten down wheel lugs... -
dTb
21:06:18 04/30/15
forgot the nut for one pulley timing belt
-
wickdGSXR
21:25:26 04/30/15
Used common steel rod for head studs. HG blew on startup.
-
LivinTheDream
21:57:31 04/30/15
^ you win lol (n/m)
-
Stanky
23:26:43 04/30/15
Ah yes, good enough for a tractor :) (n/m)
-
BigTDogg (MA)
23:17:36 05/03/15
Re: Just for kicks, name your biggest flub.
-
mxs666
22:13:44 04/30/15
Needed 4 stitches under my eye
-
RZturbo
22:25:04 04/30/15
didnt take the 20g I was once offered for the car..
-
Stanky
23:32:11 04/30/15
Did timing belt, "saved money" by using the old tensioner
-
BlackholeZ
01:57:50 05/01/15
Installed hardpipe kit, one of the bolts on the Tbolt clamps
-
Zsgetyoulaid
02:54:44 05/01/15
Pulled down the tranny on my legs, lying under the car
-
Dark Diver
04:09:59 05/01/15
Had a rubber glove fall down on the exhaust pipe during
-
jzack
10:57:50 05/01/15
Did a timing belt change and 60k service once...
-
JRH(KY)
11:55:36 05/01/15
Started my TT conversion then Bought a house and had 2 kids
-
Whip
14:57:47 05/01/15
So basically in 20 years.
-
spicyZ
22:00:33 05/01/15
Forgot to tighten bolt to main alternator power wire
-
sak01
00:38:30 05/02/15
Oh come on, Bernie! 'fess up! ;-) lol. You, too, Greg :)
-
Zuberman
01:04:56 05/02/15
Re: Oh come on, Bernie! 'fess up! ;-) lol. You, too, Greg :)
-
Dallas DamonZ
00:51:56 05/03/15
Yikes! I'm buying new safety glasses today. (n/m)
-
OverZealous (CT)
07:23:13 05/03/15
WHOA! Totally worth pestering you to share! Great that you
-
Zuberman
11:48:19 05/03/15
Pretty sure I remember a thread where Bernie
-
BlackholeZ
23:38:45 05/04/15
No idea what you're talking about...
-
Bernie (NoVA)
01:22:56 05/05/15
Left my power steering pivot bolt sticking thru the pulley
-
BigTDogg (MA)
23:15:32 05/03/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.