Subject	Does the occur in OEM stuff or only the EP setup?
Posted by	ZXoltan on April 30, 2015 at 4:11 PM
	This message has been viewed 335 times.
In Reply To	PSA posted by Dane (Houston) on April 30, 2015 at 01:48 PM
Message	Early OEM Z32's used an O-ring to ensure the seal, but Nissan later switched to a flat gasket. Apparently the o-ring was drying out and causing a potential oiling problem. They may have even issued a recall to update this (not sure about that part?). Just wondering...
Follow Ups	PSA - Dane (Houston) 13:48:07 04/30/15 wow, talk about lazy (n/m) - Adam (Utsunomiya) 14:23:03 04/30/15 (Total Hits: a lot) (n/m) - Spongerider :) 14:33:55 04/30/15 Re: PSA - Bigwill837 15:18:00 04/30/15 Welding rod in the pickup tube, or the pan? (n/m) - Krazyd27(Houston) 15:34:39 04/30/15 Re: Welding rod in the pickup tube, or the pan? - Bigwill837 15:43:36 04/30/15 Does the occur in OEM stuff or only the EP setup? - ZXoltan 16:11:42 04/30/15 There is no such recall. (n/m) - Bernie (NoVA) 16:55:30 04/30/15
Post a Followup	You cannot reply to this message because you are not logged in.