TwinTurbo.NET: Nissan 300ZX forum - Do not solder splices
People Seeking Info
 
   


     
Subject Do not solder splices
     
Posted by BlackholeZ on April 19, 2015 at 11:06 AM
  This message has been viewed 235 times.
     
In Reply To I cut that connector off and soldered the sub harness posted by itsa300zx on April 18, 2015 at 05:44 PM
     
Message correct method is a crimp splice with heat shrink over it.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" - ChristopherTheOne
" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.