Subject	The squeak is usually because the metal is galling
Posted by	BlackholeZ on April 19, 2015 at 11:04 AM
	This message has been viewed 263 times.
In Reply To	interesting, is a squeaky clutch pedal .... posted by LJZTT on April 18, 2015 at 06:35 PM
Message	All that deformation on the linkage probably caused a good bit of squeaking. Also I've heard that the end of the push rod in the master cylinder squeaks. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Guess this part (and the problem) - spyhunterTT(md) 13:01:39 04/18/15 lower control arm t-rod bolt hole (n/m) - LJZTT 13:57:48 04/18/15 How am I supposed to answer Dennis if you didn't ask me to - zgene4 14:52:08 04/18/15 Bullet hole from pot shot while driving through da hood. (n/m) - 240Z FeO2 15:03:14 04/18/15 clue #2 - spyhunterTT(md) 15:35:02 04/18/15 I change my guess to power mirror switch (n/m) - LJZTT 18:32:50 04/18/15 LMAO! (n/m) - Zuberman 09:16:41 04/19/15 Clutch pedal because the plastic bushing disentegrated - Russell@Z1 15:44:25 04/18/15 you win! (n/m) - spyhunterTT(md) 17:50:42 04/18/15 interesting, is a squeaky clutch pedal .... - LJZTT 18:35:18 04/18/15 I have well over 200k on my chassis - spyhunterTT(md) 08:22:14 04/19/15 The squeak is usually because the metal is galling - BlackholeZ 11:04:59 04/19/15 sadly, that part is continued (n/m) - spyhunterTT(md) 12:10:00 04/19/15 hm, mine has started squeaking, it's a nuisance (n/m) - LJZTT 12:54:42 04/19/15 It is annoying. - BlackholeZ 14:35:14 04/19/15 You blew the welds on the intake manifold ? !! (n/m) - josh 19:14:05 04/18/15 Ha!!! (n/m) - Jonezy 22:37:04 04/18/15 Been there done that.... - Zvil (FL) 19:06:53 04/19/15
Post a Followup	You cannot reply to this message because you are not logged in.