TwinTurbo.NET: Nissan 300ZX forum - Have you seen the TwinZ 2nd Gen fascia?
People Seeking Info
 
   


     
Subject Have you seen the TwinZ 2nd Gen fascia?
     
Posted by BlackholeZ on April 06, 2015 at 1:37 PM
  This message has been viewed 550 times.
     
In Reply To A couple questions, please (front-fascia, fender-flaps)..... posted by Zuberman on April 05, 2015 at 10:55 AM
     
Message [ http://www.z1motorsports.com/product_info.php?manufacturers_id=169&products_id=6711&osCsid=1bbo4asnbjrf6ctr84ujls5cq2 ]

It's much more aggressive while still being somewhat refined. If you were to black out the interior pieces it'd be even more intense. The problem with the Wings West is that the Z is a very curvy beast and that fascia is very... spikey. It doesn't follow the design of the car, it's more like they designed the fascia and then glued it on the front of the car. It just doesn't fit.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" - ChristopherTheOne
" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.