TwinTurbo.NET: Nissan 300ZX forum - Ehh, most 3d printed plastics are rather soft
People Seeking Info
 
   


     
Subject Ehh, most 3d printed plastics are rather soft
     
Posted by BlackholeZ on February 27, 2015 at 12:06 AM
  This message has been viewed 429 times.
     
In Reply To All you CAD savvy types, a 3d printer would pay for itself posted by LJZTT on February 26, 2015 at 10:38 PM
     
Message It'd be tough to make something that didn't vibrate horribly.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" - ChristopherTheOne
" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.