TwinTurbo.NET: Nissan 300ZX forum - Have done it lots of times with no issue. Just depends
Subject
Have done it lots of times with no issue. Just depends
Posted by
John (MD)
on October 26, 2014 at 9:35 AM
This message has been viewed
224
times.
In Reply To
Your thoughts on resurfacing a stock flywheel.
posted by njz
on October 25, 2014 at 02:04 PM
Message
on how bad your current flywheel is if at all, and how much material is left.
Follow Ups
Your thoughts on resurfacing a stock flywheel.
-
njz
14:04:11 10/25/14
Lightweight flywheel instead (n/m)
-
BarryGZX
15:16:19 10/25/14
Re: Lightweight flywheel instead
-
njz
15:41:24 10/25/14
Didn't like? (n/m)
-
BarryGZX
15:54:16 10/25/14
Re: Didn't like?
-
njz
21:13:17 10/25/14
I have stock units turned and stepped all the time. (n/m)
-
Bernie (NoVA)
19:21:33 10/25/14
This. Problems only happen if you start taking too much
-
MixManMash
07:43:10 10/26/14
Works like a champ. (n/m)
-
BoneZ (MD)
19:30:57 10/25/14
Same here, stock resurfaced with a 0.009" step. (n/m)
-
itsa300zx
22:34:48 10/25/14
Resurfacing is perfectly fine.
-
zQuikonE
01:22:19 10/26/14
Have done it lots of times with no issue. Just depends -
John (MD)
09:35:20 10/26/14
The installation instructions of any clutch require the
-
TTZ2NV(EPTmotorsports)
13:18:32 10/26/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.