Subject	Works like a champ. (n/m)
Posted by	BoneZ (MD) on October 25, 2014 at 7:30 PM
	This message has been viewed 226 times.
In Reply To	Your thoughts on resurfacing a stock flywheel. posted by njz on October 25, 2014 at 02:04 PM
Message
Follow Ups	Your thoughts on resurfacing a stock flywheel. - njz 14:04:11 10/25/14 Lightweight flywheel instead (n/m) - BarryGZX 15:16:19 10/25/14 Re: Lightweight flywheel instead - njz 15:41:24 10/25/14 Didn't like? (n/m) - BarryGZX 15:54:16 10/25/14 Re: Didn't like? - njz 21:13:17 10/25/14 I have stock units turned and stepped all the time. (n/m) - Bernie (NoVA) 19:21:33 10/25/14 This. Problems only happen if you start taking too much - MixManMash 07:43:10 10/26/14 Works like a champ. (n/m) - BoneZ (MD) 19:30:57 10/25/14 Same here, stock resurfaced with a 0.009" step. (n/m) - itsa300zx 22:34:48 10/25/14 Resurfacing is perfectly fine. - zQuikonE 01:22:19 10/26/14 Have done it lots of times with no issue. Just depends - John (MD) 09:35:20 10/26/14 The installation instructions of any clutch require the - TTZ2NV(EPTmotorsports) 13:18:32 10/26/14
Post a Followup	You cannot reply to this message because you are not logged in.