Subject	Re: thought u were onboard w the cadillac setup
Posted by	Z ONLY1 on October 05, 2014 at 3:14 PM
	This message has been viewed 257 times.
In Reply To	thought u were onboard w the cadillac setup (n/m) posted by FrozTTy on October 05, 2014 at 03:06 PM
Message	Well...yes, kind of...I am not going to use washers or spacers, structurally don't like that much stress. I am making a solid steel spacer, drilled for the 14mm bolt, mock-up the set-up, tack weld the spacer to the bracket, and then weld the spacer to the bracket. I am hoping that the 16mm hole in the bracket will allow enough movement to obtain proper alignmnet and full pad contact. The rears I am using the SRT8 calipers, just finished rebuilding those. I had bead blasted the old paint offbefore rebuild so I can change the color. Made backing plated for the brake pads which I can remove and re-use when time for new pads.
Follow Ups	she's up again.... - Z ONLY1 11:55:14 10/05/14 Didn't you just install new brakes? Oo (n/m) - FrozTTy 12:34:06 10/05/14 Re: Didn't you just install new brakes? Oo - Z ONLY1 14:01:14 10/05/14 thought u were onboard w the cadillac setup (n/m) - FrozTTy 15:06:44 10/05/14 Re: thought u were onboard w the cadillac setup - Z ONLY1 15:14:48 10/05/14
Post a Followup	You cannot reply to this message because you are not logged in.