Subject	They are not for sale at the moment...and may never be.
Posted by	Evan_Wright (Ca) on September 25, 2014 at 3:06 PM
	This message has been viewed 305 times.
In Reply To	Dude, when did you refine your original gauge? posted by bartz32tt on September 25, 2014 at 02:52 PM
Message	Although the firmware and electronics are close to being a sale-able product(even the PCB board has gone through several revisions since those pictures) I just don't have a way of producing the plastic housings at this time. It's something I'm looking into. I currently use 52mm gauge blanks and machine the necessary openings in it for the display and buttons. I'm looking into plastic mold injection. Each of these gauges can be setup to monitor two sensors. Two gauges in one. The user can select which type of sensor they have attached to which input. I Am currently coding it to work with AEM map, AEM pressure, AEM temp, and GM ethanol sensors. It also can display AFR if your wideband controller has analog output capabilities. At the very least I'll be making a full set for my car and for a few friends.
Follow Ups	anybody have experience changing screens? - fuzzymonkey 03:06:16 09/25/14 That's going to be incredibly difficult. - Antihero 10:02:30 09/25/14 interesting option - Antihero 10:08:29 09/25/14 You can always just build your own electronics from - Evan_Wright (Ca) 14:22:51 09/25/14 Dude, when did you refine your original gauge? - bartz32tt 14:52:57 09/25/14 They are not for sale at the moment...and may never be. - Evan_Wright (Ca) 15:06:25 09/25/14 Oh, and if you use it as a ethanol gauge it also provides - Evan_Wright (Ca) 15:09:33 09/25/14 I had a feeling you would say that :( - bartz32tt 16:18:03 09/25/14 Here's the best option that I've found - Multi_Read (CA) 12:16:34 09/28/14 E-mail me - ZXRider 16:23:39 09/25/14 If you need help with the gauge body I can assist. - BigTDogg (MA) 12:53:39 09/26/14 Hi Tony :) - ZXRider 13:02:13 09/26/14 To you as well dude! (n/m) - BigTDogg (MA) 13:05:16 09/26/14 Thanks for the offer of help from the three of you. Totally - Evan_Wright (Ca) 17:54:19 09/26/14 I can probably whip something up and 3D print it. - BigTDogg (MA) 14:32:25 09/27/14 Hey Tony, - Evan_Wright (Ca) 14:51:40 09/27/14 No, they don't You'll have lines and the product would look - BigTDogg (MA) 13:34:48 09/28/14 Really cool! I'll chime in with any assistance you need - J-Mart 16:21:02 09/26/14 Didn't I send you some pictures of broken Keizer aluminum - ZXRider 18:28:54 09/26/14
Post a Followup	You cannot reply to this message because you are not logged in.