Subject	If you don't bolt the rear trans mount and....
Posted by	SkiFly01 on July 11, 2014 at 11:34 AM
	This message has been viewed 338 times.
In Reply To	Top Two Bolts on the Tranny - What a B1TCH! posted by Zbullet on July 10, 2014 at 10:31 PM
Message	let the trans hang down they are actually quite easy to get to. Plus, you may need to run a tap and die set through the threads of the bolt holes to clean them up. This page in the FSM also shows the proper length of bolts that go in which hole so that you won't strip any more out in the future. Kai body kit is considered -2 on the stage chart - Guapo 10:36:58 12/14/05 AshsZ in Florida: I'm gonna fire my sh** up today 1/14/06 90% of the time ..plano soccer mom girls are hot the other 15% they are crackwhores...with the overlap. -genic 06/29/06 Drag cars have brakes? Real men have parachutes. - Bernie (NoVA) 01/13/08
Follow Ups	Top Two Bolts on the Tranny - What a B1TCH! - Zbullet 22:31:16 07/10/14 14mm universal impact socket, 30" extension, impact gun (n/m) - Bernie (NoVA) 00:38:29 07/11/14 I actually find these fairly easy, i just get it from up top - Stanky 01:36:54 07/11/14 yes you gotta go from the top. get inside the car! (n/m) - Jiro 03:04:29 07/11/14 I can get on it with a wrench from the top BUT ... - Zbullet 07:04:09 07/11/14 i just leave the top two out (n/m) - Z32TT-R 01:38:21 07/11/14 Where do you secure the ground? (n/m) - Woody75 (Denver) 09:37:46 07/11/14 From Nissan it's the first one down on the pass side. (n/m) - BlackholeZ 12:40:50 07/11/14 Its the top bolt on every Z I have worked on. (n/m) - Woody75 (Denver) 14:19:32 07/11/14 Strange - BlackholeZ 15:15:46 07/12/14 tucked bay remember ;) batt out back. (n/m) - Z32TT-R 11:56:41 07/13/14 What you need is a wobble(universal) socket - ILoveBoost 07:23:48 07/11/14 yup. easy. (n/m) - Antihero 09:23:04 07/11/14 36 inch, 1/2 drive extension and a universal - JMartz 07:32:23 07/11/14 This. Except I use a 3/8 drive extension as it gives a - MixManMash 09:15:46 07/11/14 I use 3/8 too, I also remove the shifter bracket. - itsa300zx 11:08:14 07/11/14 yup... you have freaky double jointed arms... - vorpalZ 11:40:30 07/11/14 If you don't bolt the rear trans mount and.... - SkiFly01 11:34:21 07/11/14 2nd.... let the rear of the transmission droop - SammybTT(TN) 12:16:28 07/11/14 ah yes this is key. i assumed this was being done. - Jiro 10:02:39 07/12/14 PB Blaster...nectar of the gods (n/m) - LJZTT 12:59:44 07/11/14 To swear you got them all only to pull the engine with trans - LivinTheDream 15:44:35 07/11/14 SWIVEL SOCKET = My new best friend - Zbullet 20:32:46 07/13/14 A bit of duct tape around the universal swivel joint - intel 00:41:07 07/14/14
Post a Followup	You cannot reply to this message because you are not logged in.