Subject	Engine was new shortblock that had blown and been rebuilt
Posted by	Greg (Dallas) on June 10, 2014 at 5:10 PM
	This message has been viewed 217 times.
In Reply To	Did u figure out why the bearing spun? posted by ZXoltan on June 10, 2014 at 02:25 PM
Message	In my possession the whole time. Probably detonation in #6.
Follow Ups	Closer and closer... - Greg (Dallas) 10:46:53 06/10/14 what did you do to it while it was out? (n/m) - genic 10:50:32 06/10/14 new crank, #6 bearing, & rod - Greg (Dallas) 11:28:18 06/10/14 Did u figure out why the bearing spun? - ZXoltan 14:25:00 06/10/14 Engine was new shortblock that had blown and been rebuilt - Greg (Dallas) 17:10:29 06/10/14 Did you make sure RTV wasn't clogging any oil passages? (n/m) - dvice 20:33:56 06/10/14 I'm inclined to think your rod bearing clearances were too - aliaZ 05:33:56 06/11/14 yellow bit..heh (n/m) - genic 08:15:30 06/11/14 If you were bitching before about the pipes - Woody75 (Denver) 11:55:05 06/10/14 :) (n/m) - Greg (Dallas) 12:18:28 06/10/14 Looking good. (n/m) - Boosted1 06:23:14 06/11/14
Post a Followup	You cannot reply to this message because you are not logged in.