Subject	Closer and closer...
Posted by	Greg (Dallas) on June 10, 2014 at 10:46 AM
	This message has been viewed 871 times.
Message	Engine is back in, thanks to Woody, Roy, and Mike. Slowly getting everything hooked back up. Driver's side Ashspec 2.5" pipes are now hooked up.
Follow Ups	Closer and closer... - Greg (Dallas) 10:46:53 06/10/14 what did you do to it while it was out? (n/m) - genic 10:50:32 06/10/14 new crank, #6 bearing, & rod - Greg (Dallas) 11:28:18 06/10/14 Did u figure out why the bearing spun? - ZXoltan 14:25:00 06/10/14 Engine was new shortblock that had blown and been rebuilt - Greg (Dallas) 17:10:29 06/10/14 Did you make sure RTV wasn't clogging any oil passages? (n/m) - dvice 20:33:56 06/10/14 I'm inclined to think your rod bearing clearances were too - aliaZ 05:33:56 06/11/14 yellow bit..heh (n/m) - genic 08:15:30 06/11/14 If you were bitching before about the pipes - Woody75 (Denver) 11:55:05 06/10/14 :) (n/m) - Greg (Dallas) 12:18:28 06/10/14 Looking good. (n/m) - Boosted1 06:23:14 06/11/14
Post a Followup	You cannot reply to this message because you are not logged in.