Subject	It wouldn't be too hard to make a custom controller
Posted by	Evan_Wright (Ca) on June 09, 2014 at 9:50 AM
	This message has been viewed 203 times.
In Reply To	Is it possible to make the Tein EDFC work with SPL coils? (n/m) posted by Evan(CA) on June 08, 2014 at 07:22 PM
Message	using a microcontroller, stepper motor and some sort of potentiometer for position feed back. Probably need a current sensing circuit as a safety to prevent accidental over extension of the motor. Some sort of serial interface between the controller and each motor. Ok, maybe not so simple.
Follow Ups	Is it possible to make the Tein EDFC work with SPL coils? (n/m) - Evan(CA) 19:22:33 06/08/14 Short answer from Charles: - BlackholeZ 20:17:20 06/08/14 That's unfortunate. (n/m) - Evan(CA) 20:19:08 06/08/14 It'd be a cool thing - BlackholeZ 23:37:05 06/08/14 Re: Is it possible to make the Tein EDFC work with SPL coils? - Rob260 05:10:52 06/09/14 agreed...thats route i am going (n/m) - genic 08:30:16 06/09/14 Actually... I'm not sure I agree. - Antihero 16:19:38 06/09/14 Re: Actually... I'm not sure I agree. - Rob260 08:00:42 06/10/14 Re: Re: Actually... I'm not sure I agree. - Rob260 08:01:53 06/10/14 TEIN DSP46-KUSS2 Super Street - genic 09:07:23 06/10/14 big second. I have flex and I'm going to try out the ss on a - Dane (Houston) 23:53:50 06/10/14 It wouldn't be too hard to make a custom controller - Evan_Wright (Ca) 09:50:18 06/09/14 All though, if the only thing needed to make the tein EDFC - Evan_Wright (Ca) 10:01:33 06/09/14 don't forget the torque required to spin the spinny thing (n/m) - fuzzymonkey 12:40:11 06/09/14 That is certainly not the only thing needed. (n/m) - Antihero 15:59:32 06/09/14 I was thinking some better hobby servos (n/m) - BlackholeZ 13:43:17 06/09/14 Hobby servos could work if you understand how to - Evan_Wright (Ca) 14:01:24 06/09/14 Oh yeah it would need to go >360° - BlackholeZ 14:40:08 06/09/14 I haven't come across anything like that but you could - Evan_Wright (Ca) 15:26:27 06/09/14 It's a PWM setting - BlackholeZ 15:45:36 06/09/14 That sounds like fun. - Evan_Wright (Ca) 18:11:30 06/09/14 you can measure resistance at the motor... - Antihero 17:42:54 06/09/14 True. - Evan_Wright (Ca) 18:21:57 06/09/14 Yeah the servo control boards we had didn't have voltage - BlackholeZ 17:13:04 06/10/14
Post a Followup	You cannot reply to this message because you are not logged in.