Subject	Here is Mine
Posted by	Cjw3 on June 05, 2014 at 4:26 PM
	This message has been viewed 408 times.
In Reply To	?, has anyone ever taken an engine cradle like this one posted by genic on June 04, 2014 at 08:11 AM
Message	I have a Cradle under the Front Main of the Pan.. A Block under the rear of the Trans, and the Stability is on the Exhaust Manifolds.. This is the way I drop my Motor and Trans.. Lift the Car Straight off.. Crossmember comes with the Engine Cj
Follow Ups	?, has anyone ever taken an engine cradle like this one - genic 08:11:36 06/04/14 What dorks in what picture? - ZXoltan 09:25:52 06/04/14 i might get this...hack it up...make it work for the VG - genic 10:39:00 06/04/14 I'd like to see a "kit" - ZXoltan 13:04:06 06/04/14 reading my mind (n/m) - genic 16:14:41 06/04/14 Brandon, I sent you an email (n/m) - itsa300zx 20:28:39 06/04/14 I made a temporary stand out of 4x4s... - The Sixth 10:16:03 06/04/14 if you can weld, it's easy. just fab a couple adjustable - itsa300zx 11:41:34 06/04/14 please do (n/m) - genic 12:52:15 06/04/14 Buy or borrow another stand. (n/m) - BoneZ (MD) 21:12:52 06/04/14 you could go cheap and set it down on a wooden pallet. - SkiFly01 09:46:52 06/05/14 Or you could just throw it on the concrete in the garage ;-) - ZXoltan 10:09:12 06/05/14 Sitting the engine on the oil pan in your garage - ZXRider 12:11:42 06/05/14 General mishandling causes damage - ZXoltan 05:27:01 06/06/14 I understand what everyone is talking about - ZXRider 11:46:26 06/06/14 What is the general consensus for overall use? - -Grimm- 12:36:17 06/05/14 Here is Mine - Cjw3 16:26:46 06/05/14 Used r888 works fine as a temporary solution. - ConVerTT 19:58:50 06/05/14 On a dolly for mobility :-) (n/m) - ConVerTT 20:04:57 06/05/14
Post a Followup	You cannot reply to this message because you are not logged in.