Subject	I made a temporary stand out of 4x4s...
Posted by	The Sixth on June 04, 2014 at 10:16 AM
	This message has been viewed 284 times.
In Reply To	?, has anyone ever taken an engine cradle like this one posted by genic on June 04, 2014 at 08:11 AM
Message	I had two under each motor mount and two supporting the backside. You couldn't roll it around, but I thought if I ever wanted something more permanent, I'd start with a spare front subframe. Might be the way to go since you can weld, and takes the guess work out of getting it to fit.
Follow Ups	?, has anyone ever taken an engine cradle like this one - genic 08:11:36 06/04/14 What dorks in what picture? - ZXoltan 09:25:52 06/04/14 i might get this...hack it up...make it work for the VG - genic 10:39:00 06/04/14 I'd like to see a "kit" - ZXoltan 13:04:06 06/04/14 reading my mind (n/m) - genic 16:14:41 06/04/14 Brandon, I sent you an email (n/m) - itsa300zx 20:28:39 06/04/14 I made a temporary stand out of 4x4s... - The Sixth 10:16:03 06/04/14 if you can weld, it's easy. just fab a couple adjustable - itsa300zx 11:41:34 06/04/14 please do (n/m) - genic 12:52:15 06/04/14 Buy or borrow another stand. (n/m) - BoneZ (MD) 21:12:52 06/04/14 you could go cheap and set it down on a wooden pallet. - SkiFly01 09:46:52 06/05/14 Or you could just throw it on the concrete in the garage ;-) - ZXoltan 10:09:12 06/05/14 Sitting the engine on the oil pan in your garage - ZXRider 12:11:42 06/05/14 General mishandling causes damage - ZXoltan 05:27:01 06/06/14 I understand what everyone is talking about - ZXRider 11:46:26 06/06/14 What is the general consensus for overall use? - -Grimm- 12:36:17 06/05/14 Here is Mine - Cjw3 16:26:46 06/05/14 Used r888 works fine as a temporary solution. - ConVerTT 19:58:50 06/05/14 On a dolly for mobility :-) (n/m) - ConVerTT 20:04:57 06/05/14
Post a Followup	You cannot reply to this message because you are not logged in.