Subject	agree that bonding the two is a no no. repairing that tab
Posted by	LivinTheDream on April 07, 2014 at 11:08 PM
	This message has been viewed 189 times.
In Reply To	I am NOT suggesting bonding the stack to the MAF posted by ZXoltan on April 07, 2014 at 09:03 PM
Message	Isn't that impossible. There are a lot of adhesives that should do the trick. I'm sure there are here that have favorites. I could probably only recommend New metal by man coatings. It's a part busy epoxy and its the best I've used so far. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	maf plastic housing repair - ZWolf 11:50:18 04/07/14 what I did for my cousin's Z: - Zvil (FL) 12:35:32 04/07/14 I would try JB Weld and fiberglass reinforcement. - ZXoltan 13:48:45 04/07/14 My go-to adhesive is 3M 5200 - will almost permanently bond - black300zx 20:29:58 04/07/14 I am NOT suggesting bonding the stack to the MAF - ZXoltan 21:03:46 04/07/14 agree that bonding the two is a no no. repairing that tab - LivinTheDream 23:08:37 04/07/14 Yep, I'm sure plenty epoxies up to the task. - ZXoltan 13:01:35 04/08/14 Ahh - gotcha. Agreed (n/m) - black300zx 11:29:01 04/08/14
Post a Followup	You cannot reply to this message because you are not logged in.