Subject	My go-to adhesive is 3M 5200 - will almost permanently bond
Posted by	black300zx on April 07, 2014 at 8:29 PM
	This message has been viewed 199 times.
In Reply To	I would try JB Weld and fiberglass reinforcement. posted by ZXoltan on April 07, 2014 at 01:48 PM
Message	just about anything together. It's peel-off strength is just incredible. The joint between the MAF and velocity stack will see a good bit of torque from the pop-charger and intake tee, so something rigid like JB weld might be prone to peeling.
Follow Ups	maf plastic housing repair - ZWolf 11:50:18 04/07/14 what I did for my cousin's Z: - Zvil (FL) 12:35:32 04/07/14 I would try JB Weld and fiberglass reinforcement. - ZXoltan 13:48:45 04/07/14 My go-to adhesive is 3M 5200 - will almost permanently bond - black300zx 20:29:58 04/07/14 I am NOT suggesting bonding the stack to the MAF - ZXoltan 21:03:46 04/07/14 agree that bonding the two is a no no. repairing that tab - LivinTheDream 23:08:37 04/07/14 Yep, I'm sure plenty epoxies up to the task. - ZXoltan 13:01:35 04/08/14 Ahh - gotcha. Agreed (n/m) - black300zx 11:29:01 04/08/14
Post a Followup	You cannot reply to this message because you are not logged in.