Subject	I installed the clutch, but everything was fine when
Posted by	spdrmn15 on April 06, 2014 at 8:33 PM
	This message has been viewed 159 times.
In Reply To	Did you do the last clutch replacement or someone else? (n/m) posted by puchy on April 06, 2014 at 11:07 AM
Message	It was all bolted together(engine was out of the car at the time). "Face it, you just can't beat stupid." "Never underestimate the power of stupid people in large groups" "My favorite glue is Hopes and Dreams. " "My Z runs on gas and money."
Follow Ups	Some hopefully minor engine damage. - spdrmn15 09:33:39 04/06/14 Did you do the last clutch replacement or someone else? (n/m) - puchy 11:07:18 04/06/14 Thats the question... (n/m) - CmyZ 13:56:10 04/06/14 I installed the clutch, but everything was fine when - spdrmn15 20:33:52 04/06/14 Could the crank seal retainer have not been seated - Summeronthechain (MN) 11:40:08 04/06/14 Might be the probable cause... (n/m) - CmyZ 13:57:06 04/06/14 This. Or prying/banging too hard removing/inserting the seal (n/m) - ConVerTT 14:16:07 04/06/14 I bet someone tried to change the seal between the pan - aliaZ 15:18:07 04/06/14 It was fully seated, the only thing that changed after - spdrmn15 20:42:02 04/06/14 Do not resize bolts. Just use a tread repair kit (n/m) - Bernie (NoVA) 12:37:44 04/07/14 Do the hole with Time-sert. not Helicoil (n/m) - kickerzx 13:21:29 04/06/14 I would do all of them also (n/m) - -Grimm- 14:12:57 04/06/14 What is the thread size/pitch for the flywheel bolts? (n/m) - spdrmn15 20:49:59 04/06/14 M10x1.00 - Bernie (NoVA) 22:33:24 04/06/14 Dayum. (n/m) - zgene4 17:05:15 04/07/14
Post a Followup	You cannot reply to this message because you are not logged in.