Subject	I had issues fitting my Ashspec massive under the a-spec
Posted by	Evan_Wright (Ca) on April 06, 2014 at 3:22 PM
	This message has been viewed 284 times.
In Reply To	VIS Racing JDM fascia intercooler options question posted by Matt300ZXT on April 06, 2014 at 01:10 AM
Message	fascia. The lower outer edge of the intercoolers stuck out to far and pushed out on the fascia. Not sure why I had this issue and most others say they don't. Anyways, the j-spec fascia looks like it has extra clearance in just the right spot that should make it an easier fit.
Follow Ups	VIS Racing JDM fascia intercooler options question - Matt300ZXT 01:10:04 04/06/14 Greddy IC's fit stock ducts and do not interfere with turn - LJZTT 02:18:50 04/06/14 Re: Greddy IC's fit stock ducts and do not interfere with turn - Matt300ZXT 09:45:58 04/06/14 I have no idea, if you dont need massive IC's I dont see the - LJZTT 11:41:38 04/06/14 I have godspeeds under my vis replica with no ducts - PYROhafe 15:55:01 04/06/14 awesome (n/m) - LJZTT 16:04:51 04/06/14 That's too bad (n/m) - Bernie (NoVA) 20:42:09 04/06/14 Re: That's too bad - PYROhafe 21:05:02 04/06/14 Because your install is half assed. - Bernie (NoVA) 22:37:58 04/06/14 but he says they work GREAT, so they must be cooling charge - LJZTT 12:05:12 04/07/14 I had issues fitting my Ashspec massive under the a-spec - Evan_Wright (Ca) 15:22:24 04/06/14 this area also does not mate up very well between the jspec - LJZTT 16:27:07 04/06/14 Is there any downside to the VIS vs the JDM fascia? - MrOzzie5183 09:35:54 04/07/14 I've seen two cars with them installed - Jayru 11:44:30 04/07/14 That's the input I was looking for ;) - MrOzzie5183 13:24:05 04/07/14 jspec doesnt necessarily go on like a a lego either - LJZTT 14:37:10 04/07/14 Well I have. In both occasions there were gaping holes - Jayru 14:45:13 04/07/14
Post a Followup	You cannot reply to this message because you are not logged in.