Subject	KongZTT, michaell32 thanks for the advice, I wish I could
Posted by	Tanley on April 04, 2014 at 9:14 PM
	This message has been viewed 229 times.
In Reply To	If your arms are small enough a 14mm ratchet wrench is posted by michaell32 (FL) on April 04, 2014 at 08:51 PM
Message	run air tools, but I live in a condo complex and the neighbors would have a shit fit if I ran a compressor. I've used a bunch of 3/8 extensions connected before with a ratchet. I remember there was a lot of flex, felt like I was losing a lot of torque so figure I'd buy a beefier one this time. I remember using a 14mm wrench on a few of the bolts, but that was 50 lbs ago, I'll give it a shot though. Again, thanks for the advice, seems like it won't matter which one I go with if I decide to buy one.
Follow Ups	3' 1/2" Extension for transmission bolts, which one - Tanley 20:20:16 04/04/14 you're over thinking it... - KongZTT GT28RS MD 20:43:23 04/04/14 btw.. I prefered a 3/8" drive impact and sockets for this (n/m) - KongZTT GT28RS MD 20:44:29 04/04/14 2nd - 3/8 works... (n/m) - jzack 22:45:13 04/04/14 ^^3rd 3/8 are easier to handle and get into the tight areas (n/m) - SammybTT(TN) 23:32:05 04/04/14 4th! I found the 8" wobbler extensions are most flexible. - OverZealous (CT) 10:20:34 04/05/14 If your arms are small enough a 14mm ratchet wrench is - michaell32 (FL) 20:51:15 04/04/14 KongZTT, michaell32 thanks for the advice, I wish I could - Tanley 21:14:42 04/04/14 you don't need a compressor if you have one of these - aliaZ 21:48:27 04/04/14 Nice! I could definitely use one of those. (n/m) - Tanley 22:37:43 04/04/14 $500+ ??? Ouch! (n/m) - OverZealous (CT) 10:15:08 04/05/14 nah...$397 on amazon for the impact gun with 1 battery - aliaZ 09:11:09 04/06/14 LOL - you got some skinny arms friend... - ConVerTT 22:24:07 04/04/14 5'11 and 150lbs. Ive tried to lift weights, eat more and - michaell32 (FL) 22:27:31 04/04/14 Well you have picked the right car :-) (n/m) - ConVerTT 23:36:19 04/04/14 Yup, just use what you were given! Good plan! (n/m) - The Hawk 13:12:08 04/05/14 2nd! That definitely won't work for me at 185lb. (n/m) - OverZealous (CT) 10:16:50 04/05/14 I was able to tighten a number of them that way but - jzack 22:44:00 04/04/14 1/2 both ends - -Grimm- 12:42:40 04/05/14 Take the 6 bolts for the rear trans bracket out first. - rcmadness 09:27:34 04/06/14
Post a Followup	You cannot reply to this message because you are not logged in.