Subject	Re: Re: Planning on TT swap and being that the motor will be out
Posted by	DJ2_300zxLover on April 03, 2014 at 7:11 PM
	This message has been viewed 181 times.
In Reply To	Re: Planning on TT swap and being that the motor will be out posted by plusdaddy on April 03, 2014 at 06:54 PM
Message	Alright thanks sounds good, injectors manifolds and down pipes are good then.. I wouldnt need 2.5 inch intercooler piping right?
Follow Ups	Planning on TT swap and being that the motor will be out - DJ2_300zxLover 13:35:01 04/03/14 What should be done first? - ZXRider 15:48:59 04/03/14 ^^^Exactly.. - Zinister1 16:25:07 04/03/14 ^ All of it and then some (n/m) - -Grimm- 17:14:32 04/03/14 Ive spent 4x what I had initially "budgeted" for - Zsgetyoulaid 01:14:32 04/04/14 Re: Planning on TT swap and being that the motor will be out - plusdaddy 18:54:01 04/03/14 Re: Re: Planning on TT swap and being that the motor will be out - DJ2_300zxLover 19:11:08 04/03/14 If you can I would add ash's inlet piping as well. - michaell32 (FL) 19:20:33 04/03/14 Yep, change all the rubber horses. I've never gained any - ForceFedTT (SoCal) 21:55:24 04/03/14 Excellent point! - ConVerTT 22:54:09 04/03/14 Re: Re: Planning on TT swap and being that the motor will be out - sdvdoc 12:07:12 04/04/14 It's not what you want to hear but it's the truth. - Evan(CA) 19:21:13 04/03/14 740cc new style injectors. (n/m) - Antihero 19:59:04 04/03/14 Agreed. No point in getting 555s, since they cost the same. (n/m) - Nate (NoVA) 08:22:33 04/04/14 Truth. (n/m) - Mike TDK (NoVA) 16:22:47 04/04/14 Don't forget the clutch - MrOzzie5183 20:13:07 04/03/14 STOP! You need a LOT more than that for a swap... - ConVerTT 20:50:09 04/03/14 This forum rocks. Sage advise from YOUR profile DJ2.... - ConVerTT 23:02:37 04/03/14 Harness, 120k kit, valve cover gaskets, rear main seal, - TTZ2NV(EPTmotorsports) 10:37:08 04/04/14 converTT you are right i am lazy lol but i just wanted to - DJ2_300zxLover 20:53:26 04/04/14 I hear you. There is a ton of info on this site... - ConVerTT 22:12:46 04/04/14
Post a Followup	You cannot reply to this message because you are not logged in.